Spare Time.

I’ve gathered together most of the bits for the assembly of the spare wheel carrier which, when rigged, will allow me to establish finally, the shape of the turtle deck. I was pushing the car out for a photo session last weekend when I noticed that the body is slightly raised at the back. This is probably because the rear springs aren’t doing as much work as the front ones so the weight of the spare wheel, the battery box and a tank full of fuel may help matters. If not, I’ll have to make some adjustments in the skinning to get the right look or maybe take a leaf or two out of the springs to soften up the tail.

Profile

In fact, I met up with Awkward & Leon the other night ….

Night run

… and they remarked that the rear springs may be too stiff per se. But that’s the sort of thing that I’ll find out only by going down the road.

Open cockpit night driving is always invigorating and reminds me that in the Austin, a dash light over the oil pressure gauge would be a handy fit. I could use one of the two period Lucas items I’ve got for the Hillman – one for each side of the cockpit – but that would deprive Miss X of her map-reading light. Tricky.

Carrier

But, getting back to the carrier… I asked Chumley to knock me up a tube (for the usual consideration) that tapered in both directions and which will slip over the spreader bar on the back of the chassis. To the tapered tube will be welded the 6mm steel spine for the back of the skiff.

Spare wheel carrier revision

In reality, the spare is going to be positioned a lot lower than at first envisaged. I tried a couple of positions and, although it’s not the prettiest arrangement in the world, the profile works best when the top of the tyre is more or less level with the top of the turtle deck.

Profile

The low level of the hub gives me a more pronounced triangulation for the structure – something I was hoping to achieve after the first jury rig.

Rear view

Of course, the siting of the spare wheel has thrown up another snag which I’ll have to work round. I was hoping to put the rear light clusters on the aluminium cover which is going to attach to the chassis rails and give the body a bit more flow to the rear end; that’s no longer possible. I’ll have to think again and either have them on stalks – not a favourite – or somehow incorporate them into the wings where at the greater height, at least they’ll be more visible.

Top plate

And this is the top plate which will carry the load strut. I’m almost too embarrassed to mention it but I managed to get the measurements for that wrong and had to disc-cut a lump from the other side of the fold. I’ll have to drill new bolt holes as well – the ones I specified are just too close to the edge on the vertical flange of the chassis cross member.

Maybe I should take measuring lessons in my spare time?

Advertisements

4 comments on “Spare Time.

  1. renaud says:

    “Maybe I should take measuring lessons in my spare time?”
    Don’t or only if you can get free ones because your kind seems like a “cause perdue” in that department…
    Renaud

  2. renaud says:

    Yeees, but beware, “errare humanum est, perseverare diabolicum”.
    Renaud

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s